Some office buildings are equipped with two-story lift garages. When encountering such three-dimensional garages, many car owners complain that parking is difficult, and those who are not technically hard enough even complain about it. In fact, it may seem difficult, but as long as you drive properly, use the rearview mirror and vehicle auxiliary equipment cleverly, it is not difficult to park safely.

Experience parking: use smartly and don't worry, reversing slowly and carefully.

    Link 1: Find the right starting position. There is an old saying: "A good start is half of the success"; on the contrary, a wrong start is the majority of failures. This is the case with reversing the warehouse. It’s important to reverse the car at 90 degrees and where to park is very important. Various experiences have shown that the vehicle is more than 2 meters vertically from the parking space, which is relatively easy to enter the warehouse; the smaller the vertical distance, the more likely it is to cause a small turning angle, and it is not easy to enter the warehouse. .

At the beginning of the experiment, first choose to enter the warehouse from the front right of the parking space. At first, I chose the distance to be too short and the reversing was getting closer and closer to the parking space. As a result, it was found that the parking space with a narrow distance between the right rear wheel of the vehicle began to overlap. Because there are small raised iron plates on both sides of the parking garage, once the tires are pressed up, the parking will fail. .

After driving the car for a long distance for the second time, after slowly reversing this time, the right wheel just entered the side of the warehouse, and the distance was about 1-2 cm, and the left side was also the same. To sum up, generally speaking, the vertical distance of 2 meters from the parking space is just right, and the rear of your car is right in front of the adjacent parking space.

    Session 2: Don't rush to give directions. When the reporter adjusts the direction and enters the warehouse, he should pay attention to the left and right rearview mirrors, make full use of the rearview mirrors, and observe the storage angle and the distance between the tires and the side of the warehouse. At this time, the speed should be slow, and it should be convenient to adjust the position at any time. It is a problem for many novices because of tension leading to premature steering and too fast driving. Under normal circumstances, when reversing, wait for the C-pillar of the car to pass the front of the adjacent car, and then start steering at a constant speed and control the speed, then you can enter the parking space according to the correct arc.

    No. 3: Storage at a constant speed, making good use of vehicle auxiliary equipment. At this time, after the vehicle is perpendicular to the parking space, look at the position of the left and right rear tires from the side of the garage through the rearview mirror, and then fall backward at a uniform speed. At this time, it should be noted that the parking space is a bit higher than the ground, so there is an uphill board transition between each parking space and the ground, and you need to increase the accelerator. When refueling, you should also use the middle rearview mirror or the reversing image, combined with the reversing radar prompt sound, to prevent objects behind from entering the library slowly. When you hear the reversing radar prompt or see the reversing image prompting to approach the bottom of the storage, you must step on the brakes, and the tires will lightly touch the bottom of the storage. At this time, you can declare the reversing success, and do not slam the accelerator.

Veteran driver talks about experience: stop a few more times, accumulate experience based on your car

    1. Find a parking space according to the size of your vehicle. Before parking in the stereo garage, you must first determine the size of the parking space and whether it is suitable for your car. Most three-dimensional garages have clear restrictions on the length, width, and height of the parked vehicle and the weight of the vehicle. If you are driving a medium-sized car or a sedan below, the impact will not be significant, but if it is a medium-to-large car or a luxury car, you need to pay special attention to the length of the car. The common standards for the length of the three-dimensional garage are 4.7 meters, 5 meters and 5.2 meters. Wait, everyone chooses as needed. If you are driving a "big car" such as Buick Rongyu, Mercedes-Benz S-Class, BMW 7 Series, or Buick Encore, Cadillac Escalade, etc., I suggest that you don’t consider the stereo garage. General parking lots will be right. These models are given preferential treatment and provide ground parking spaces.

    2. Keep a vertical distance from the parking lot to the left and right of the car body, and pay attention to the corners. After finding a suitable parking space, you can choose whether to reverse 90 degrees into the garage or reverse diagonally according to your daily reversing habits. No matter what kind of reversing method is used, a certain distance should be properly left between the body and the parking space. If conditions permit, a distance of about one lane can be left. If the space is limited, try to ensure that there is a margin of about 2 meters. , To facilitate observation and detour.

    3. Don't rush to pour it at once, you can move it several times if necessary. For a well-skilled driver, it’s okay to reverse the car into the parking space after determining the distance around the body. But if you are not very sure, don’t be anxious. After the car is fully aligned with the parking space, you can go straight in again.

    4. Pay attention to the rear of the car and make full use of various auxiliary equipment in the car. When the vehicle is reversed into the parking space, the driver should pay more attention to the situation at the rear of the vehicle. At this time, you can make full use of the reversing radar and reversing image in the car according to your own habits to help your own judgment.

    5. Control the throttle, pass the limit belt, and fully enter the parking space to stop. The last step of parking is to let the rear wheel press over the limit zone. Since the limit zone generally has a slight slope, the driver needs to add a little throttle at this time, but you must pay attention to the control of the throttle force and you can test it. Slowly refuel, don't hit the accelerator directly, or the rear of your car will be easily injured.

    6. It is not recommended to drive in with the front of the car, as it is very difficult to have an inner wheel gap. When the vehicle is turning, there will be an inner wheel difference (the difference between the turning radius of the inner front wheel and the turning radius of the inner rear wheel when the vehicle is turning). Board risk. And many parking garages do not allow parking in this way. Even if you park your car, the administrator will come over and ask you to stop again.